Heath-consultants Sure-Lock All Pro Manual de usuario Pagina 1

SURE-LOCKAll ProUser Manual®

7THE SURE-LOCK TRANSMITTER(Figure 1-2) 1. OUTPUT FREQUENCIES: Frequencies are selectable combinations of 8.1 kHz, 81 kHz, and 480 kHz, a

814. cm D), typical.15. WEIGHT: 8 lbs. (3.6 kg), typical.16. CONSTRUCTION: Weat

9A B C D E FI JGKHFigure 1-2(Transmitter)A. Battery Charger Jack G. DisplayB. Safety

10WARNING! SAFETY FIRST!Check for and turn off all power sources before connecting the trans-mitter directly to otherwise power carrying cables.Direc

11A. Signal Power Indicator (SPI) B. Left-Right Indicator C. Battery Status Indicator D. Lock IndicatorE. On-Off/Volume SwitchF. Bubble LevelG

12ControlsThe receiver has several unique features, controls, and indicators with which the operator must become familiar (Figure 1-4).1. DISPLAY: Th

13e. Lock Indicator - The LOCK indicator is a unique feature of Sure-Lock. When the LOCK indicator appears on the display, the receiver is locked to

14of the operator. The second one is higher in pitch and corresponds to the conductor being to the right of the operator. When the receiver is positio

15CHAPTER IIGENERAL OPERATING PROCEDURESOPERATING PROCEDURESThis portion of the manual is broken down into the TRANSMITTER and RE-CEIVER sections. Th

161. Inductive or Indirect Connect2. Conductive or Direct Connect3. 4. 5.

Proprietary NoticeThe contents of this manual are proprietary to Heath Consultants Incorporated. Reproduction of this manual, in whole or in part, is

17One of the pitfalls the operator must recognize is that when the transmitter is functioning in the inductive mode, other conductors in the area may

18Figure 2-2(Transmitter positioned on its end directly over the interfering conductor. This position will energize the target conductor and apply min

19Figure 2-3(Transmitter positioned on its end for closer tracing applications. This set-up will reduce the air coupling distance)ConductorTwo Operato

20Figure 2-4(Operators properly positioned to begin the two operator sweep)Figure 2-5(Two operator sweep. The operators have energized and located the

21Conductive (Direct Connect) ModeWhenever possible, the conductive method is preferred for energizing the con-ductor. By using a direct hookup, the o

22must be aware at all times of where the grounding cables run and what is used as a ground. The cables are carrying the full signal current, and, if

23Two coupler clamps (see USING DUAL COUPLER CLAMPS, page 24) can also be used in Dual Jacking.(Correct - Grounding Application)(Incorrect - Grounding

241. INSTRUCTIONS FOR SINGLE COUPLER CLAMP USE: Before using the coupler clamp, refer to the coupler clamp applications section which 

25allow the signal to propagate.In such situations, this conductor loop must be closed. The coupler clamp comes equipped with a bridging cable which c

26(Correct - Grounding attachment allows signal (Correct. - The coupler clamp jaws are closed around the conductor. The conductor is energized)

SURE-LOCK®Heath Consultants IncorporatedHouston, TX713-844-1300 Fax: 713-844-13091-800-HEATH-USwww.heathus.comHeath...Safety, Leadership, Innovation,

271. ONCE THE CONDUCTOR IS PROPERLY ENERGIZED:a. Turn the receiver on and select the appropriate frequency matching that on the transmitter. 

28 Left Lock RightFigure 2-10

29above indicators) and the receiver is positioned directly above the

30These results may also indicate that the operator should reposition the transmit-ter or go to a different transmitter mode of operation to energize

31CHAPTER IIIMAINTENANCEBATTERY CHARGING AND REPLACEMENT INSTRUCTIONSLow Frequency TransmittersThe Sure-Lock low frequency transmitters are equipped w

32 positive ends of the batteries (opposite the spring ends) to avoid damaging the

33It is suggested that when the Sure-Lock is not in use, it should be kept in its 

341. 12 VDC BATTERY CHARGER (HPN 6710777): Used to charge the transmitter battery from a 12 VDC power source such as a vehicle’s cigarette lighter. O

WARRANTY AND WARRANTY REPAIRSThe Sure-Lock instruments are warranted for two years.All other instruments and products manufactured by Heath Consultant

RETURN AUTHORIZATION (RA)1. Contact Heath Customer Service at 1-800-432-8487 fo

FUNCTIONThe Sure-Lock® is a state-of-the-art, multi-frequency cable and pipe locator system 

CUSTOMER ASSISTANCE, MANUFACTURING AND SERVICE LOCATIONSCORPORATE HEADQUARTERSHeath Consultants Incorporated9030 Monroe RoadPhone:

Heath...Safety, Leadership, Innovation, PerformanceThen, Now and TomorrowHeath Consultants IncorporatedHouston, TX713-844-1300Fax: 713-844-13091-800-

2TABLE OF CONTENTSFunction ... 1CHAPTER I - GENERAL DESCRIPTIONDescription

3  Using the Receiver ...

4CHAPTER IGENERAL DESCRIPTIONDESCRIPTION OF SYSTEM COMPONENTS(See Figure 1-1) TransmitterThe Sure-Lock® multi-frequency transmitter combines numerous

5Coupler Clamp (Optional)An alternate direct method of energizing the conductor is with a coupler clamp. This device can be used with the transmitter

6ABCDEFGHIJKLA. Transmitter G. Grounding PlateB. Receiver H. Grounding Spike D. Manual J. Conductive Cabl